How to install the Auto Alarm System?

Did you still worry about install the alarm system? Now, Guangzhou Guangpai Auto Products Co., Ltd ( www.gpauto-products.com ) will share the experience with you about install the alarm system. Guangzhou Guangpai Auto Product Co., Ltd specialized in auto push button start system, have own brand “GPPOWER”. The market not only spread all over China, but also Southeast Asia. There are exclusive agent in most provinces and cities of China. Also cooperate with the 4S store of TOYOTA, HONDA, VW, Skoda and so on. Meanwhile, our company supplies push button starter and keyless entry system to Japan, USA, Brazil, Russian, Africa, etc.

First: Preparatory Work

1. Tool

Wire stripper, Electroprobe (12V-24V), Screwdriver, Insulating tape, Knife, Double faced adhesive tape, ribbon and other tool.

2. Install diagram

Read the install circuit diagram and install introductions carefully, operate accordance with the install circuit diagram strictly, ensure all wiring is correct.

Second: Erection sequence

1. Confirm the car have the central lock or not before install

If yes: Judge the trigger form. When install the burglar alarm, can connect the wire with the “central lock wiring diagram” according to the install diagram.

Notice: If cannot judge the trigger form, then connect wire with positive & negative trigger according to the “central lock wiring diagram”, ensure the central lock work well.

If not: Install the central lock first.

2.  Confirm the installation site

Take down dale which under dash board, ensure the install site for inner system main host, alarm main host, antenna and other parts ( must according to the installation diagram ), pay attention to dustproof, waterproof. Arrange for wiring.

3. Test wire, connect wire, and assign circuit

Test Wire: Test and find out the wire which need to connect according to the installation diagram
Assign circuit: When assign the circuit, try the best to make the wire take cover and beautiful, make the wire little long from junction to the main host.
Connect wire: Test the wire, make sure and connect the wire one by one, advice make mistake.

Requirement for wiring: Wire connects closeness, advice not connect, wrap up with the insulating tape. This step is most important during installation. If connect the wire fault, the alarm system useless or the inner component will be burned up, make the vehicle cannot be use normal.

As the above, it is the preparation work for install auto alarm system. Next time, Guangzhou Guangpai Auto Parts Co., Ltd. will share the install detail with you. More information, welcome to scan GPPOWER ( www.gpauto-products.com ).